# Austin Repipe Cost Calculator

> Repipe cost calculator for Austin and nearby cities: typical ranges for a repipe, slab leak reroute, water line or burst pipe, with permit and pressure lines.

URL: https://gracklerepipingaustin.com/tools/repipe-cost-estimator/

## Estimate your house

The range depends on the job and, for a whole-house repipe, on PEX and access. Stories, bathrooms, attic access and tile show where in the range a house tends to land; they never change the numbers.

## How the estimate works

The figures are typical Austin-area ranges, not quotes. No answer you give scales them: there are no multipliers and no square-foot math, and open upper ends stay open. What you answer decides which range applies and which notes and separate lines appear.

Code lines come from the [City of Austin's adopted plumbing code](https://www.austintexas.gov/development-services/building-technical-codes). Permit lines come from each city's published schedule. For context on labor, the Bureau of Labor Statistics puts the mean plumber wage in the Austin metro at $30.65 an hour against $34.70 nationally ([BLS](https://www.bls.gov/oes/current/oes_12420.htm)). A wage is not a billing rate.

## What each job shows

| Job | The calculator shows |
| --- | --- |
| Whole-house repipe | $4,500 to $15,000+, a typical Austin-area range; copper and long slab runs sit toward the top or above |
| Whole-house repipe in PEX, typical access | about $4,500 to $9,000+ |
| Slab leak reroute | about $4,000 to $9,750, before leak detection |
| Water line, meter to house | about $1,500 to $5,000+; open trench about $50 to $185 per foot as a national budgeting range |
| Burst pipe repair, pipe work only | about $400 to $1,500+ |
| Partial repipe | No range; the drivers, and a price after a walk-through |

### Never inside the range

- The plumbing permit, a pressure regulator and leak detection, each shown as its own line
- A replacement water heater and new fixtures
- Patching and painting, unless the estimate lists it
- Drain and sewer lines, which are a separate system

[Austin repipe cost guide](https://gracklerepipingaustin.com/guide/repipe-cost-austin/) · [Not sure what you need? Repair, reroute or repipe](https://gracklerepipingaustin.com/tools/repipe-assessment/) · [Printable planning checklist](https://gracklerepipingaustin.com/resources/)

## Questions about the calculator

### Why does the calculator give a range instead of a price?

Because the price of a repipe depends on things only a walk-through settles: the routes new pipe can take, the finishes in the way and the pressure at the house. The calculator shows the typical Austin-area range for the job, $4,500 to $15,000+ for a whole-house repipe, and what pushes your house toward the high end.

### Why is there no range for a copper repipe or a partial repipe?

Local figures for copper disagree too much on the low end to publish a range honestly, and a partial repipe depends entirely on its scope. The calculator shows the whole-house range for copper with a note that copper sits toward the top, and lists the drivers for a partial repipe.

### Does the calculator include the permit fee?

It shows the permit as its own line. Austin's fee comes from the City's schedule and is confirmed for the address; a failed inspection costs $83.85 to reinspect. Round Rock lists a standalone plumbing permit at $50.